Author Topic: Installed DNA Preformance Air filer  (Read 9060 times)

0 Members and 3 Guests are viewing this topic.

#90

Offline AlexItaly

  • ZH2 Member
  • **
  • Posts: 86
  • Country: it
  • Town / City: teramo
Re: Installed DNA Preformance Air filer
Reply #90 on: January 23, 2021, 09:53:55 AM
@yav92: I've seen on Dynojet website the power commander is available as well as the map, serial 17-085-000. I suppose you coldn't use this map because of the modification of the gear. Is it right? That's why you had to install an autotune?

#91

Offline yav92

  • ZH2 Member
  • **
  • Posts: 61
  • Country: il
  • Bike: Z-H2 2020
  • Town / City: Kiryat Ono
Re: Installed DNA Preformance Air filer
Reply #91 on: January 23, 2021, 02:25:37 PM
The map is completely different
Eu model vs US model.
As well I decat the exhaust and stage 1 gear. I also installed o2 sensor eliminator so I can tune the map from scratch

#92

Offline AlexItaly

  • ZH2 Member
  • **
  • Posts: 86
  • Country: it
  • Town / City: teramo
Re: Installed DNA Preformance Air filer
Reply #92 on: January 23, 2021, 04:02:04 PM
Oh I see!

I'm going to follow exactly your same steps, you've been a very good inspiration! In addition I've already reduced the transmission ratio, by installing 17 teeth front sprocket, 520 instead of 525 .
So, may I ask you where did you get your map? Was it developped by you? I've seen you have a test bench!

#93

Offline yav92

  • ZH2 Member
  • **
  • Posts: 61
  • Country: il
  • Bike: Z-H2 2020
  • Town / City: Kiryat Ono
Re: Installed DNA Preformance Air filer
Reply #93 on: January 23, 2021, 04:11:59 PM
The map i used pcv5 and autotune
I put my AFR target and went to ride to build the map..
Then I test it on my dyno.. easy

#94

Offline AlexItaly

  • ZH2 Member
  • **
  • Posts: 86
  • Country: it
  • Town / City: teramo
Re: Installed DNA Preformance Air filer
Reply #94 on: January 23, 2021, 05:05:38 PM
I understand! Sorry for that much questions...I'm familiar with mechanical stuff and old carburetors...never tried with ECU!
When you say AFR, you mean the Air Fuel Ratio I suppose. So your target was to made the mix more lean, to reduce fuel consumption? As far I know, but I ignore the matter for supercharged engines, the standard AFR on the Autotune-PowerCommander shouldn't be touched...Unless you have a precise idea...of your target   :001:

 



chaos